Ultra
Perfect+ comes to you with a Digital Timer switch
and LED display
...Line
Drawing
...Timer
Setting Procedure
Connect
the wire cord on power supply and switch on
Timer
beeps once to indicate that power is on
Immediately
the display shows the previous value of set time
in minutes
To
set / alter a new grinding time, press the up / down
key to the desired time in minutes. While pressing
keys buzzer fitted in the timer will give beep sound.
You can set a range between 00 to 99 minutes
Warning
of long beep sound will come from timer when you try
to press the up / down key to set beyond 99 and 00
respectively
After
setting the require time, press the start key to start
the grinding operation. Long beep sound indicates
starting and the LED starts flashing to indicate the
lapsing of time in seconds
After
completing 60 such flashes of red LED, the timer display
will be reduced by 1 minute and display indicates
the balance time
2
Minutes before completion of the set time, you can
hear a long beep sound indicating that the grinding
is nearing completion
During
the last 30 seconds, beep comes for each flashing
and finally a long beep will come which indicates
that the grinding is over and the unit will stop automatically
...Power
failure / Interception of set time
If
case of any power failure during operation display
will go off and at resumption, LED display will
flash with beep sound
Press
the ON key for restarting the grinder. The balance
time will be displayed in the LCD and the grinder
will run for the remaining time
