What's wrong
Reasons
What to do
1
 Unit does not run No power supply Check Mains
2
 Unit starts but drum stops suddenly
Overloading of medium Remove medium and add in small quantities.
Low belt tension Contact nearest Service point.
Insufficient water Add water as required
3
 Unit is noisy Incorrect wiper position Check and correct the wiper position as printed on Arm lid.
4
 Increase in grinding time
Excess quantity, insufficient soaking time Reduce quantity or check manual for correct operation.
Incorrect wiper position Check and correct the wiper position as printed on Arm lid.
Low voltage Operate at 230 V Ac 50 Hz /
110 Ac V 60 Hz
Low belt tension Contact nearest Service point
5
 Unit overheating
Motor housing air vents blocked Use a dry brush to clean air vents
External heat source Check
6
 Vibration Uneven platform Check level
7
 Unit / Drum smells
Motor burnt Contact nearest service point.
Drum / Roller assembly not cleaned well Clean
8
 Unit stops automatically when it is switched on Faculty switch Contact nearest service point
9
 Arm does not lock Roller assembly not cleaned well Clean and use the Roller Holder Assembly
10
 Roller not rotating
Roller not cleaned properly after use. Unscrew roller and clean under running water.
Excessive loading / insufficient water Remove excess material / Add Water
ANGLER Technologies